
It is really no secret that GDDR6X memory can operate quite sizzling on graphics cards geared up with it, most notably the GeForce RTX 3080, RTX 3080 Ti, and RTX 3090, some of the very best graphics playing cards on the market place. If modding copper shims to your GPU isn’t your cup of tea, you can find an simpler way to cut down memory temperatures. YouTuber DandyWorks released a online video demonstrating the use of a copper plate for memory, created specifically for an Nvidia RTX 3080. The copper plate was equipped to decrease GDDR6X temperatures by up to 25C.
The copper plate employed in the video was built by CoolMyGPU.com and is exclusively intended for decide on RTX 3080 AIB companion playing cards. The business has an assortment of other copper memory cooling pates as effectively that are made for a range of RTX 30-sequence GPU models, such as the RTX 3080/Ti, RTX 3090, RTX 3060/Ti, and RTX 3070/Ti. It has plates for Nvidia’s Founders Version SKUs as effectively as some third social gathering models.
For RTX 3090 proprietors, CoolMyGPU.com also sells a rear memory copper plate to support amazing the rear GDDR6X modules on the card. This plate could be even far more helpful than the entrance plate, due to the fact the RTX 3090’s rear G6X modules are notorious for working really hot, with the backplate remaining the only source of warmth dissipation for the rear modules.
In the video clip, DandyWorks showcases how to set up the copper memory cooling plate on to an MSI Ventus RTX 3080 graphics card. Very first, the graphics card’s initial cooler desires to be removed. Following, all the thermal pads and thermal paste cooling the GDDR6X and main GPU main need to be removed, together with any more residue still left from the thermal pads.
Just after a check fit, the copper cooling plate can now be installed, sandwiched involving a layer of thermal paste on the top and bottom, along with the installation of the GPU heatsink. No extra screws are demanded since the plate is held down by the GPU’s cooling answer.
For Dandy’s RTX 3080 Ventus graphics card, the copper plate dropped memory temperatures 20%, likely from 94C to just 75C in mining applications, with even reduce temperatures documented though gaming.
When Need to This Mod Be Applied?
In our knowledge testing Nvidia’s flagship RTX 30-sequence cards — such as AIB companion types — the suitable GDDR6X temperatures should peak at 100C or reduced to ensure thermal throttling isn’t going to manifest. You may be alright with 105C peak temps, but if your GPU’s memory is operating at 110C or higher, the graphics card will throttle clock speeds and much better cooling is required.
Gaming-specific workloads are likely to be a bit fewer demanding than mining, but we’ve tested cards (like the RTX 3080 Ti Founders Version) wherever memory temperatures strike 104C on a common foundation. Fireplace up a mining utility and 110C takes place on a great deal of GDDR6X-geared up playing cards, like just about all of Nvidia’s Founders Version designs (with the exception of the RTX 3070 Ti, which only has 8GB VRAM). Only the ‘good’ AIB partner cards with improved memory cooling capabilities remain underneath that mark.
So if you find your GPU is managing at 110C — even though mining or gaming — this copper cooling plate mod would be a way to cut down GPU temperatures. It should really allow the GDDR6X to operate at its maximum clock rate, and therefore strengthen performance and card longevity. It may be an even improved choice if all you do with your GDDR6X card is mining, while with mining gains dropping, that may not be as needed these times.